Lacquer sanding machines are equipped for this task with:

The electro-pneumatic segmented pad permits an intensive but careful sanding of the endangered side, front and rear edges.

The elastic segmented pads optimally compensate for frequent tolerances within or between workpieces up to 2 mm max. without sanding through.

The intermeshing pressure shoes which ensure gentle transitions on the surface and which avoid streaking.

Wide segmented pad for a uniform surface sanding.

The frequency-controlled sanding abrasive belt drives with a wide regulation range, permitting the belt speed to be infinitely adapted to the individual lacquer and stain quality.

Servo drives allow minimum sanding belt speeds of 0.1 m/s.

Wide range of structuring and smoothening brushes for special finishing effects.

Thorough sanding belt cleaning, preventing sanding marks resulting from adhering dust grains.

Different interfaces serve as the prerequisite for linking into lacquer lines.

High gloss sanding

For high gloss surfaces the combination of cross and longitudinal sanding belts is established.

High-Gloss production with a machine configuration CR./P/CR./CR.

When working with a machine with 3 cross units and 1 piano sanding unit, 3 to 4 passes through the machine are necessary for sanding raw MDF material up to the finished product if it is sanded with a grit of 600 or 800. If melamine-laminated MDF material has to be sanded, the first working step could possibly be saved. The special advantage of a machine with 4 units is that no more than one pass through the machine in between the individual lacquering processes is required.